This fits your .
- Make sure this fits by entering your model number.
- Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
- Software support for Windows, Mac, and Linux.
- Direct high-speed USB support with no drivers required, a true plug and play device.
- Spektrum satellite receiver support integrated.
- Supports OpenPilot GCS Software
Note: Please don’t flash/Update the Default firmware. Updated or new firmware may cause a problem of connectivity with PC/Laptop.
The CC3D board is an all-in-one stabilization hardware flight controller, which runs the OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the powerful and user friendly OpenPilot software.
The CC3D is an update to the original Copter Control board, now using the powerful single chip IMU. The board shares a lot with the Revolution platform, including the powerful OpenPilot architecture and the cross-platform Ground Control Station (GCS). The CopterControl platform has been designed from the ground up to perform a host of functions from auto-level, multi-copter, Fixed wing UAV’s and even Flybarless Helicopter support. The new included Flexiport provides either I2C connectivity or a second serial port.
MultiRotor controller with auto-level, including TriCopters, QuadCopters and HexaCopters
Flybarless Helicopter controller with auto-level
Fixed Wing UAV controller
Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM
3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer
Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performance.
Software support for Windows, Mac and Linux
Direct high speed USB support with no drivers required, a truly plug and play device.
Spektrum satellite receiver support
Futaba S-BUS hardware support and PPM
Innovative Flexi-port technology for superior port flexibility
4Mbits on-board EEPROM for configuration storage
Mounting: M3 holes @ 30.5mm square
CC3D Flight controller Rev C
NOTE: Color may vary, some PCBs will be delivered in a black finish.
OpenPilot CC3D Evo Flight Controller 32-bit Case Side Pin 90 Degree +Cables B077Z5WNMC